Removing The Fork Protector; Installing The Fork Protector; Removing The Engine Guard (Rockstar Edition) - Husqvarna FC 450 2020 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.5
11.6
11.7
54

Removing the fork protector

S01902-10

Installing the fork protector

S01902-11

Removing the engine guard (ROCKSTAR EDITION)

K01065-10
–
Clean and oil the dust boots and inner fork tubes of both fork
legs.
Universal oil spray ( p. 158)
–
Press the dust boots back into the installation position.
–
Remove the excess oil.
Finishing work
–
Install the fork protector. (
–
Remove the motorcycle from the lift stand. (
–
1
Remove screws and take off the clamp.
–
2
Remove screws and take off the left fork protector.
–
3
Remove screws and take off the right fork protector.
–
Position the fork protector on the left fork leg. Mount and
1
tighten screws .
Guideline
Remaining screws,
chassis
–
Position the brake line and clamp. Mount and tighten
2
screws .
–
Position the fork protector on the right fork leg. Mount and
3
tighten screws .
Guideline
Remaining screws,
chassis
–
1
Remove screws .
p. 54)
p. 52)
M6 10 Nm (7.4 lbf ft)
M6 10 Nm (7.4 lbf ft)