Startup Time Settings - Canon imageCLASS MF4690 Reference Manual

Before Using the
Machine 1
Document and Paper
2
Copying
3
Sending and
Receiving 4
Printing and
Scanning
5
Network
6
Remote UI
7
System Manager
Settings
8
Maintenance
9
Troubleshooting
10
Appendix
11
Table of Contents
Index
3.
Press [ ] or [ ] to select <NETWORK
SETTINGS>, then press [OK].
4.
Press [ ] or [ ] to select <TCP/IP SETTINGS>,
then press [OK].
5.
Press [ ] or [ ] to select <PERMIT RX MAC
ADD>, then press [OK].
6.
Press [ ] or [ ] to select <ON> or <OFF>,
then press [OK].
<OFF>: Disables a MAC address filter.
<ON>: Enables a MAC address filter.
If you select <ON>, you will be unable to access from MAC addresses
which have not been specified.
7.
Press [ ] or [ ] to select from <PERMIT RX
ADD1> through <PERMIT RX ADD5>, then press
[OK].
Back Previous
8.
Use the numeric keys to enter the MAC address
of the computer allowed to access the machine,
then press [OK].
Repeat step 7 and 8 to specify other MAC addresses.
9.
Press [Stop/Reset] to return to the standby
mode.
10.
Restart the machine.

Startup Time Settings

■
If you connect the machine to a switching hub, it may not be able
to connect to a network even though your network settings are set
correctly.
This occurs because the spanning tree process performed between
switching hubs prevents them from communicating with each
other immediately after the machine connects to a switching hub.
In this case, use the following procedure to delay the startup of
network communication.
1.
Press [Additional Functions].
TOP
Next
6-41