Before Using the
Machine
1
Document and Paper
2
Copying
3
Sending and
Receiving
4
Printing and
Scanning
5
Network
6
Remote UI
7
System Manager
Settings
8
Maintenance
9
Troubleshooting
10
Appendix
11
Table of Contents
Index
Using Coded Dial Codes
■
You can specify up to 192 destinations using coded dial codes.
To use this feature, you must register destinations in coded dial code
beforehand. (See "Storing/Editing Address Book, " on p. 4-9.)
1.
Set documents.
Place the first page on the platen glass if you are not using the ADF.
2.
Press [SEND/FAX] repeatedly to select the
sending method, then press [OK].
To send documents to a file server, select any sending method.
3.
Press [ Coded Dial].
Back
Previous
4.
Enter the desired three-digit code (000 to 191)
with the numeric keys.
Ex.
T E L = 0 1 2 3 X X X X X X
[ * 0 0 1 ] C A N O N
If you entered a wrong code, press [Clear], then try again from step 3.
If you want to adjust the image quality and density, see "Scan
Settings, " on p. 4-6.
5.
Press [Start].
When you set the documents on the platen glass, press [
to select the document size, then press [Start] for each document.
When scanning is complete, press [OK] to start sending.
When <TIME OUT> is set to <ON> in <TX SETTINGS> in <FAX
SETTINGS> in <TX/RX SETTINGS>, and if you have specified the
destination by any other method than using numeric keys, the
machine starts scanning automatically without pressing [Start], after
the preset time for this setting is elapsed.
TOP
Next
] or [
]
4-21