Canon imageCLASS MF4690 Reference Manual page 121

Before Using the
Machine 1
Checking and Deleting Jobs
Document and Paper
2
Copying
3
Sending and
Receiving 4
Printing and
Scanning
5
Network
6
Remote UI
7
System Manager
Settings
8
Maintenance
9
Troubleshooting
10
Appendix
11
Table of Contents
Index
System monitor enables you to view the transmission and
reception results, monitor the status of the send and receive
jobs currently being processed.
Checking Transmission/Reception Results
■
1.
Press [System Monitor] repeatedly to select <TX/
RX LOG>, then press [OK].
If you set <CHECKING THE LOG> to <OFF> in <SYSTEM SETTINGS>,
transmission/reception result does not appear in the LCD.
2.
Press [ ] or [ ] to view the required
transmission/reception result.
3.
Press [Stop/Reset] to return to the standby
mode.
Back Previous
Checking the Arrival of I-Fax
■
The machine regularly checks for the arrival of I-fax. However,
you can check for the arrival of I-fax at any time using the System
Monitor key.
To be able to check the arrival of I-fax using the System Monitor key, you
must first set <POP> (Post Office Protocol) to <ON>, so that you can receive
documents using POP. (See "Setting Up E-Mail, " on p. 6-16.)
1.
Press [System Monitor].
2.
Press [ ] or [ ] to select <I-FAX>, then press
[OK].
3.
Press [ ] or [ ] to select <CHECK RX I-FAX
JOB>, then press [OK].
The machine starts checking the arrival of I-fax and receives them.
TOP
Next
4-47