Before Using the
Machine
1
Document and Paper
2
Copying
3
Sending and Receiving (MF6595cx/
MF6595/MF6590 Only)
4
Printing and
Scanning
5
Network (MF6595cx/MF6595/
MF6590/MF6540 Only)
6
Remote UI (MF6595cx/MF6595/
MF6590/MF6540 Only)
7
System Settings
8
Maintenance
9
Troubleshooting
10
Appendix
11
Table of Contents
Index
6.
Press [
] or [
] to select <ON> or <OFF>,
then press [OK].
<OFF>: Disables a MAC address filter. Skip to step 10.
<ON>: Enables a MAC address filter.
If you select <ON>, you will be unable to access from MAC addresses
which have not been specified.
7.
Press [
] or [
] to select from <PERMIT RX
ADD1> through <PERMIT RX ADD5>, then press
[OK].
8.
Use the numeric keys to enter the MAC address
of the computer allowed to access the machine,
then press [OK].
9.
Repeat step 7 and 8 to specify other MAC
addresses.
10.
Press [Stop] to return to the standby mode.
11.
Restart the machine.
Back
Previous
Startup Time Settings
■
If you connect the machine to a switching hub, it may not be able
to connect to a network even though your network settings are set
correctly.
This occurs because the spanning tree process performed between
switching hubs prevents them from communicating with each
other immediately after the machine connects to a switching hub.
In this case, use the following procedure to delay the startup of
network communication.
The default setting is <60SEC>.
1.
Press [Additional Functions].
2.
Press [
] or [
] to select <SYSTEM
SETTINGS>, then press [OK].
3.
Press [
] or [
] to select <NETWORK
SETTINGS>, then press [OK].
4.
Press [
] or [
] to select <STARTUP TIME
SET.>, then press [OK].
TOP
Next
6-18