Canon imageCLASS MF4690 Reference Manual page 311

Before Using the
Machine 1
Document and Paper
2
Copying
3
Sending and
Receiving 4
Printing and
Scanning
5
Network
6
Remote UI
7
System Manager
Settings
8
Maintenance
9
Troubleshooting
10
Appendix
11
Table of Contents
Index
Q Are the settings for <PERMIT RX MAC ADD>
correct?
A If the MAC address of a computer specified in
<PERMIT RX MAC ADD> is not correct, you cannot set
the machine setting items or browse information on
the machine. Check the settings for <PERMIT RX MAC
ADD>. (See "RX MAC Address Settings, " on p. 6-40.)
Q Is <USE SNMP> or <DEDICATED PORT> is to
<OFF>?
A Set <USE SNMP> and <DEDICATED PORT> to <ON>.
(See "SNMP, " on p. 6-8.)
Q Does the SNMP community name match?
A If you use an SNMP community name different from
the one stored in the machine to access the machine
from a utility, the utility will not detect the machine.
In this case, check the SNMP community name. (See
"SNMP, " on p. 6-8.)
Back
Unable to send data/share files (Windows File Sharing).
Q Are File sharing settings for the shared folder
correct?
A Check the following settings:
– On the computer you are using, go into Windows
Explorer → double-click [Entire Network] → check
that the computer you want to share is listed there.
You can also check for the computer as follows: On
the [Start] menu, point to [Find] → [Computer] →
enter the name of the computer you want to share
→ check that the computer is on the network.
– If the computer you want to share is listed, double-
click its icon to see whether the shared name of the
folder you want to share is listed.
– If the shared name does not appear, see
"Configuring a Shared Folder, " on p. 6-23 and then
check the shared folder settings.
Q Is an error message or code displayed on the LCD
of the machine?
A After confirming the error message, see "LCD
Messages, " on p. 10-13 and perform the necessary
operations according to the error message displayed.
TOP
Previous Next
10-54