Canon imageCLASS MF4690 Reference Manual page 101

Before Using the
Machine 1
Document and Paper
2
Copying
3
Sending and
Receiving 4
Printing and
Scanning
5
Network
6
Remote UI
7
System Manager
Settings
8
Maintenance
9
Troubleshooting
10
Appendix
11
Table of Contents
Index
5.
Press [Start].
When you set the documents on the platen glass, press [
to select the document size, then press [Start] for each document.
When scanning is complete, press [OK] to start sending.
When <TIME OUT> is set to <ON> in <TX SETTINGS> in <FAX
SETTINGS> in <TX/RX SETTINGS>, and if you have specified the
destination by any other method than using numeric keys, the
machine starts scanning automatically without pressing [Start], after
the preset time for this setting is elapsed.
Job Recall
■
You can recall the last three destinations, scan settings, and send
settings which have been set, and then send your documents.
When <REST. REDIAL/CALL> is set to <ON>, [Recall/Pause] is not available.
(See "Restricting Job Recall, " on p. 8-19.)
1.
Set documents.
Place the first page on the platen glass if you are not using the ADF.
2.
Press [SEND/FAX].
] or [ ]
3.
Press [ Recall/Pause].
4.
Press [
BEFORE>, or <3 BEFORE>, then press [OK].
5.
Confirm that the desired recipient is displayed.
You can change the recalled scan and send settings if necessary.
6.
Press [Start].
When you set the documents on the platen glass, press [
to select the document size, then press [Start] for each document.
When scanning is complete, press [OK] to start sending.
When <TIME OUT> is set to <ON> in <TX SETTINGS> in <FAX
SETTINGS> in <TX/RX SETTINGS>, and if you have specified the
destination by any other method than using numeric keys, the
machine starts scanning automatically without pressing [Start], after
the preset time for this setting is elapsed.
Back Previous Next
] or [ ] to select <1 BEFORE>, <2
TOP
] or [ ]
4-27