Oracle SPARC T8-1 Installation Manual page 69

2. Set the SP to accept a static IP address.
->set /SP/network pendingipdiscovery=static
Set 'pendingipdiscovery' to 'static'
3. Set the IP address for the SP.
->set /SP/network pendingipaddress=service-processor-IPaddr
Set 'pendingipaddress' to 'service-processor-IPaddr'
To change the default IPv6 DHCP property and set property values for a static IPv6 address,
refer to the section
ILOM Administrator's Guide for Configuration and Maintenance.
Set the IP address for the SP gateway.
4.
-> set /SP/network pendingipgateway=gateway-IPaddr
Set 'pendingipgateway' to 'gateway-IPaddr'
Set the netmask for the SP.
5.
-> set /SP/network pendingipnetmask=255.255.255.0
Set 'pendingipnetmask' to '255.255.255.0'
This example uses 255.255.255.0 to set the netmask. Your network environment subnet might
require a different netmask. Use a netmask number most appropriate to your environment.
6. Verify that the parameters were set correctly.
This example shows parameters that have been set to convert a SP from a DHCP configuration
to a static configuration.
-> show /SP/network -display properties
/SP/network
Targets:
Properties:
commitpending = (Cannot show property)
dhcp_clientid = xxx.xxx.xxx.xxx
dhcp_server_ip = xxx.xxx.xxx.xxx
ipaddress = xxx.xxx.xxx.xxx
ipdiscovery = dhcp
ipgateway = xxx.xxx.xxx.xxx
ipnetmask = 255.255.255.0
macaddress = xx:xx:xx:xx:xx:xx
managementport = MGMT
outofbandmacaddress = xx:xx:xx:xx:xx:xx
pendingipaddress = service-processor-IPaddr
pendingipdiscovery = static
pendingipgateway = gateway-IPaddr
Modifying Default Connectivity Configuration Properties
Assign a Static IP Address to the NET MGT Port
in the Oracle
Powering On the Server for the First Time 69