Attach The Cma To The Server - Oracle SPARC T8-1 Installation Manual

Ensure that the two Velcro straps located on the front slide bar are threaded through the
Note -
opening in the top of the slide bar as shown in
interfering with the expansion and contraction of the slide bar when the server is extended out
of the rack and returned into the rack.

Attach the CMA to the server.

6.
See "Attach the CMA to the Server" on page
Related Information
"Attach the CMA to the Server" on page 41
■
"Verify Operation of Slide Rails and CMA" on page 47
■
Attach the CMA to the Server
Before attaching the CMA to the server, ensure that the correct cable covers are installed on the
CMA.
1. Prepare the CMA for installation on the server.
See "Prepare the CMA for Installation" on page
2. To make it easier to install the CMA, extend the server approximately 13 cm (5
inches) out of the front of the rack.
3. Take the CMA to the back of the equipment rack, and ensure that you have
adequate room to work at the back of the server.
References to "left" or "right" in this procedure assume that you are facing the back of
Note -
the equipment rack.
Throughout this installation procedure, support the CMA and do not allow it to hang
Note -
under its own weight until it is secured at all four attachment points.
4. Install the CMA's connector A into the left slide rail.
Insert the CMA's connector A into the front slot on the left slide rail until it
a.
locks into place with an audible click (panels 1 and 2).
Step 2. This prevents the Velcro straps from
41.
38.
Attach the CMA to the Server
Installing the Server 41