Table of Contents
Advertisement
Connect Cables
If you power on the server for the first time and do not have a terminal or terminal
Note -
emulator (PC or workstation) connected to the SP SER MGT port, you will not see system
messages.
2.
Connect a Category 5 (or better) RJ-45 cable from the NET MGT port to your
network switch or hub.
The SP network management port is labeled NET MGT. After the initial server configuration,
you can connect to the SP over an Ethernet network using this NET MGT port.
If your network uses a DHCP server to assign IP addresses, the DHCP server assigns an IP
address to this NET MGT port. With this IP address, you can connect to the SP using an SSH
connection. If your network does not use DHCP, this NET MGT port is not accessible until
Powering On the Server for the First Time
53
Advertisement
Table of Contents
