Table of Contents
Advertisement
Programme settings
Drying unit
Cooling down
pause
96
The additional "Drying" function accelerates the drying process at the
end of the programme.
When the drying function is activated and the door is closed, the dry-
ing system feeds heated and HEPA-filtered air into the wash cabinet
for active drying of the load. The heated air is discharged through the
steam condenser and can be cooled down if necessary (see "Further
settings/Air cooling").
A cooling down pause can be inserted between the end of the final
rinse phase and starting of the drying system. During this pause, wa-
ter vapour is extracted from the wash cabinet and condensed by the
steam condenser. This reduces the moisture level in the wash cab-
inet, which promotes drying.
...
Cooling down pause
Cooling down pause
No
–
The drying unit starts immediately after the rinse phase without a
cooling down pause.
Time
–
The cooling down pause is activated for a duration which can be
set.
Select an option using the and arrow buttons and confirm your
selection with OK.
Time
When
has been selected, the duration of the cooling down
pause must then be set.
The setting value is entered in increments of 10 seconds. The pos-
sible range is shown in the bottom line of the display.
Use the arrow buttons (higher) and (lower) to set the duration
of the cooling down pause.
Press OK to save the setting.
No
Time
Cooling down pause
120
s
s )
(0 - 600
Advertisement
Table of Contents
