Configuring the
interface
Ethernet
The interface must only be configured by suitably qualified and
competent persons.
Open the menu as follows:
button
Further settings
Interface
Interface
Ethernet
RS232
Ethernet
–
Configuration of an Ethernet interface
RS232
–
Configuration of a serial RS-232 interface
Select the type of interface and confirm your selection with OK.
Then the parameters for the interface must be configured.
Module status
–
Connection status displayed (
Address status
–
List of interface parameters, e.g. IP address, Subnet mask etc.
DHCP
–
The Ethernet interface can either be implemented via a Dynamic
Host Configuration Protocol (DHCP) or by setting the following
parameters:
–
IP address
–
Subnet mask
Standard gateway
–
DNS server automatic
–
DNS server 1
–
DNS server 2
–
Port type
–
Port
–
Further settings
Active
Inactive
/
).
83