Table of Contents
Advertisement
Warning and Safety instructions
14
This machine complies with all statutory safety requirements. Inap-
propriate use can, however, lead to personal injury and material
damage.
Read these instructions carefully before using it for the first time to
avoid the risk of accidents and damage to the machine.
Keep these instructions in a safe place where they are accessible
to users at all times.
Correct application
Use of the machine is only permitted for the applications expressly
approved in the operating instructions. Alterations or conversion of
the machine, or using it for purposes other than those for which it
was intended, are not permitted and could be dangerous.
The cleaning and disinfection processes are only designed for med-
ical devices which are designated reprocessable by the manufacturer.
Instructions issued by load and instrument manufacturers must be
heeded.
This machine is intended for indoor use only.
Risk of injury
Please pay attention to the following notes to avoid injury
The machine may only be commissioned, repaired and maintained
by the W&H Customer Service Department or a service technician
authorised by the manufacturer of the machine. A W&H service con-
tract is recommended to ensure full compliance with medical device
regulations (such as the German Medical Device Ordinance). Incor-
rect repairs can cause considerable danger to users.
Do not install the machine in an area where there is any risk of ex-
plosion or of freezing conditions.
In order to reduce the risk of water damage, the area around the
machine should be limited to furniture and fittings that are designed
for use in commercial environments.
Some metal parts pose a risk of injury/being cut. Wear cut-resist-
ant protective gloves when transporting and setting up the machine.
If the machine is built under, it must only be installed under a con-
tinuous worktop run which is firmly secured to adjacent units to im-
prove stability.
The electrical safety of the machine can only be guaranteed when
it is correctly earthed. It is essential that this standard safety require-
ment is observed and regularly tested. If in any doubt, please have
the electrical installation inspected by a qualified electrician. W&H or
the manufacturer cannot be held liable for the consequences of an in-
adequate earthing system (e.g. electric shock).
Advertisement
Table of Contents
