Table of Contents
Advertisement
Adding and dispensing chemical agents
Checking con-
sumption
Refill indicator
Dispensing liquid
cleaning agent
52
Place the container on the floor next to the machine or in an adja-
cent cupboard. The container must not be placed on top of or
above the machine. Make sure that the dispensing hose is not
kinked or trapped.
The dispensing system must then be vented (see "Settings /DOS
venting").
Check consumption regularly by checking the fill levels in the supply
containers and replace containers in good time to avoid the dispens-
ing system being sucked completely dry.
When the fill level is low in the
cleaning agent you are reminded to replenish it.
Confirm the message shown with OK and
replenish the liquid cleaning agent as described.
If the liquid cleaning agent has run out, the machine will be locked
for further use.
It will be ready for use again when the supply container has been
replaced.
The dispensing concentration is set by W&H Service.
DOS 1
supply container for liquid
DOS
Refill
Advertisement
Table of Contents
