Leds In Buttons - W&H teon + RID-200 Operating Instructions Manual

LEDs in buttons

The buttons on the control panel have LEDs (Light Emitting Diodes). They indicate the
status of the machine.
Button LED
 button
ON
FLASHES
OFF
Programme se- ON
lection but-
tons , 
and 
OFF
 button
ON
OFF
 button
ON
OFF
Start/Stop ON
button
FLASHES
GREEN
FLASHES RED
OFF
 button
ON
FLASHES
OFF
Status
The machine is switched on.
The machine is ready for use.
The machine is switched off.
The respective programme has been selected. At the
end of the programme the LED will remain lit until a
different programme is selected.
The programme is not selected or the programme
settings are being selected.
A programme has been selected from the pro-
gramme list. At the end of the programme the LED
will remain lit until a different programme is selected.
No programme has been selected from the list or the
programme settings are being changed.
The additional "Drying" function has been activated
for the selected programme (not available for all pro-
grammes, see "Programme chart").
The additional "Drying" function has been deactiv-
ated.
A programme is running.
A programme has been selected but not yet started.
A fault has occurred (see "Problem solving guide").
A programme has finished.
The door is closed (locked) and there is no pro-
gramme running.
A programme has finished and the door is closed
(locked).
A programme is running or the door is open (un-
locked).
Guide to the machine
13