Table of Contents
Advertisement
Removing the
lid
Steam condenser
Preventing heat
build-up
Building under a continuous worktop
To build the machine under a continuous worktop the lid must be re-
moved as follows:
Unscrew both securing screws from the lid at the back of the ma-
chine.
Open the door.
Unscrew the left and right fixing screws.
Lift the lid off.
To avoid steam damage to the worktop the protective foil supplied
(25 x 58 cm, self-adhesive) must be applied underneath the work-
top in the area of the steam condenser.
During the drying phase, the hot exhaust air from the wash cabinet is
released into the surrounding environment through the steam con-
denser at the rear of the machine. Sufficient ventilation must be en-
sured to prevent heat build-up and excessive condensation.
Leave a minimum distance of 10 mm for air exchange between the
machine and the worktop.
If necessary ventilation grilles should be fitted in the side units.
Installation
139
Advertisement
Table of Contents
