Startup; Shutdown; Remote Control - Vitek VT-TNR818P Manual

2.1.1

Startup

Connect the output display device to the VGA/HDMI interface of the NVR.
Connect the mouse and power. The device will boot and the power LED will turn blue.
A WIZARD window will pop up (you should select the display language the first time you
use the NVR). Refer to 3.1 Startup Wizard for details.
2.1.2

Shutdown

You can power off the device by using remote control or mouse.
By remote controller:
Press Power button. This will take you to a shutdown window. The unit will power off
by clicking "OK" button.
Disconnect the power.
By mouse:
Click StartàShutdown to pop up the Shutdown window. Select "Shutdown" in the
window. The unit will power off by clicking "OK" button.
Disconnect the power.

2.2 Remote Control

Two AAA size batteries.
Open the battery cover of the remote control.
Place batteries. Please observe the polarity (+ and -).
Replace the battery cover.
Key points to check in case the remote doesn't work.
1. Check batteries polarity.
2. Check the remaining charge in the batteries.
3. Check IR controller sensor for any blockage.
Button
Power Button
Record Button
-/-- /0-9
Fn1 Button
Multi Button
Next Button
14
Transcendent NVR Series
Function
Switch off—to stop the device
To start recording
Input number or choose camera
Future Use
To choose multi screen display mode
To switch the live image