Motion Alarm; Motion Configuration - Vitek VT-TNR818P Manual
4, 8, 16, 32, and 64 channel 8 megapixel h.265 real time network video recorders with 4k hdmi output
Hide thumbs
Also See for VT-TNR818P:
- User manual (186 pages) ,
- Manual (104 pages) ,
- Quick start manual (12 pages)
Table of Contents
Advertisement
Transcendent NVR Series
click
to set the camera as the trigger camera. Select trigger camera on the right side and
then click
trigger cameras will record automatically when the sensor alarm is triggered.
Snap: check it and then the "Trigger Snapshot" window will pop up automatically. Configure
the trigger camera in the window. The trigger cameras will snap automatically when the sensor
alarm is triggered.
Alarm-out: check it and then the "Trigger Alarm-out" window will pop up automatically.
Configure the trigger alarm-out in the window. The system will trigger the alarm-out
automatically when the sensor alarm is triggered. You need to set the delay time and the
schedule of the alarm outputs. See 9.4.1 Alarm-out for details.
Preset: check it and then the "Trigger Preset" window will pop up automatically. Configure the
trigger preset of each camera. To add presets, please see 6.2 Preset Setting for details.
Buzzer: if enabled, the system will begin to buzz when the sensor alarm is triggered. To set the
delay time of the buzzer, please see 9.4.4 Buzzer for details.
Pop-up Video: After camera setting, the system will pop up the corresponding video
automatically when the sensor alarm is triggered. To set the duration time of the video, please
see 9.4.3 Display for details.
Pop-up Message Box: if enabled, the system will pop up the corresponding alarm message box
automatically when the sensor alarm is triggered. To set the duration time of the message box,
please see 9.4.3 Display for details.
E-mail: if enabled, the system will send an e-mail when the sensor alarm is triggered. Before
you enable the email, please configure the recipient's e-mail address first (see 11.1.4 E-mail
Configuration for details).
9.2 Motion Alarm
Motion Alarm: when the motion object appears in the specified area, it will trigger the alarm.
You should enable the motion of each camera first and then set the alarm handling of the
camera to complete the whole configuration of the motion alarm.
9.2.1
Motion Configuration
Click StartàSettingsàCameraàMotion to go to the following interface.
to cancel the trigger camera. Click "OK" button to save the settings. The
63
Advertisement
Table of Contents
