View Backup Status; Alarm Management; Sensor Alarm - Vitek VT-TNR818P Manual
4, 8, 16, 32, and 64 channel 8 megapixel h.265 real time network video recorders with 4k hdmi output
Hide thumbs
Also See for VT-TNR818P:
- User manual (186 pages) ,
- Manual (104 pages) ,
- Quick start manual (12 pages)
Table of Contents
Advertisement
8.4.4
View Backup Status
Click StartàBackupàBackup Status or click
playback interface to view the backup status.
9.1 Sensor Alarm
To complete the entire sensor alarm settings, you should enable the sensor alarm of each
camera and then set up the alarm handling of each camera.
Click StartàSettingsàAlarmàSensor Alarm to go to the following interface.
Select the alarm type (NO or NC) according to trigger type of the sensor.
Enable the sensor alarm of each camera.
Check the "Record", "Snap", "Alarm-out" and "Preset" and enable or disable the
"Buzzer", "Pop-up Video", "Pop-up Message Box" and "E-mail" as required.
Click "Apply" to save the settings.
The configuration steps of the above mentioned alarm linkages are as follows.
Record: check it and then the "Trigger Record" window will pop up automatically (you can
also click "Configure" button to pop up the window). Select camera on the left side and then
9 Alarm Management
Transcendent NVR Series
on the tool bar at the bottom of the
62
Advertisement
Table of Contents
