Web Lan Access; Web Wan Access - Vitek VT-TNR818P Manual

11.8 Web LAN Access

Click StartàSettingsàNetworkàTCP/IPv4 to go to the "TCP/IPv4" interface. Set the IP
address, subnet mask, gateway, preferred DNS and alternate DNS of the NVR.
Open IE browser on a computer, input the IP address of the NVR in the IE address bar and
then press enter to go to the login interface as shown below. You can change the display
language on the top right corner of the login interface. Input the username and password of the
NVR in the interface and then click "Login" to go to the live preview interface.
Notes: 1. Please make sure that the IP address of the NVR and the computer are both in the same
local network segment. For example, supposing that the IP address of the computer is
192.168.1.41, the IP address of the NVR shall be set to 192.168.1.XXX.
2. If the HTTP port of the NVR is not 80, but other number instead, you need to input the IP
address plus port number in the IE address bar when accessing the NVR over network. For
example, the HTTP port is 81. You should enter http://192.168.1.42:81 in the IE address bar.

11.9 Web WAN Access

NAT Access
Ø
Set the network of the NVR. Please refer to 11.1.1 TCP/IPv4 Configuration for details.
Enable NAT and then set the NAT server address. Please refer to 11.1.6 NAT
Configuration for details.
Open IE
http://www.autonat.com/n9000 in the IE address bar and then press enter to go to the interface
as shown below (download and install the relative plugin according to the popup tip if you
access the NVR through NAT for the first time).
browser on a computer, input
84
Transcendent NVR Series
the NAT server address