Add/Edit Camera Group; Add Camera Group - Vitek VT-TNR818P Manual

Transcendent NVR Series
The IP camera which directly connects to the PoE port of the NVR through private
l
protocol will be shown automatically in the camera list.
One of the two conditions must be met if the IP camera which directly connects to the PoE
l
port of the NVR through ONVIF protocol should be shown automatically in the camera list.
ü The IP camera which directly connects to the PoE port is in the same network segment
with the internal Ethernet port.
ü The DHCP (obtain an IP address automatically) of the IP camera which directly
connects to the PoE port is enabled.
If the IP camera which connects to the PoE port cannot be displayed automatically in the
camera list, please refer to Q6 in Appendix A FAQ for details.

4.2 Add/Edit Camera Group

4.2.1

Add Camera Group

Click "Edit Camera Group" in the above interface to go to the interface as shown below.
29