Audio Output:
Connect PTZs via RS485 interfaces:
PTZ Connection
Type 1: The B (Tx-) /A (Tx+) interface are used to connect speed dome (PTZ).
2
Basic Operation
Make sure that all connections are properly connected. Proper startup and shutdown are
2.1 Startup and Shutdown
crucial to expending the life of the DVR.
①
Connect the power.
②
The device will boot and the power LED will turn blue.
③
A WIZARD window will pop up and show some information about time zone, time
setup, network configuration, record configuration and disk management..
Note: Change Display Resolution by pressing ESC key on DVR/Switch on Remote
from VGA to HDMI output
You can power off the device by using remote control or mouse.
①
Click Menu Button; select Shutdown from pop up window. Unit will start power off
By keyboard and mouse:
sequence by clicking "OK". Press "CANCEL" to return to Menu. Disconnect the power.
①
2.2 Remote Control
②
Use two AAA size batteries.
③
Open the battery cover of the remote control.
④
Insert batteries. Please take note of the polarity (+ and -).
Replace the battery cover.
Transcendent DVR Series
8