Advanced Configuration; Encode Parameters Setting - Vitek VT-TNR818P Manual

supports H.265, or the option will be H.264 only.
Resolution: the higher the resolution is, the clearer the image is.
FPS: the higher the frame rate is, the more fluid the video is. However, more storage room will
be taken up.
Bitrate: the higher the image quality you choose, the more bit rate will be required.
Manual Mode
Ø
If the manual mode is selected, you need to set the encode parameters and record schedules of
each camera. See 7.2 Encode Parameters Setting and 7.3 Schedule Setting for details.
7.1.2

Advanced Configuration

Click StartàSettingsàRecordàAdvanced to go to the following interface. Enable or disable
cycle record (cycle record: the earliest recorded data will be replaced by the latest when the
disks are full). Set the pre-alarm record time, post-alarm record time and expiration time of
each camera and then click "Apply" to save the settings.
Pre-alarm Record Time: set the time to record before the actual recording begins.
Post-alarm Record Time: set the time to record after the actual recording is finished.
Expiration Time: set the expiration time for recorded video. If the set date is overdue, the
recorded data will be deleted automatically.

7.2 Encode Parameters Setting

Click StartàSettingsàRecordàEncode Parameters to go to the interface as shown below. Set
the video encode, resolution, FPS, bitrate and audio of main stream for each camera in "Event
Record Stream" and "Timing Record Stream" interfaces. Click "Apply" to save the settings.
You can set the record stream of each camera one by one or batch set them for all cameras.
Transcendent NVR Series
46