Nat Configuration; View Network Status; Basic Configuration; Common Configuration - Vitek VT-TNR818P Manual

Set the NVR's IP address, subnet mask and gateway and so on corresponding to the
router.
Check "Enable" in the interface as shown below and then click "Apply" button.
Click "Refresh" button to refresh the UPnP status. If the UPnP status were still "Invalid UPnP"
after refreshing it for many times, the port number would be wrong. Please change the mapping
type to "Manual" and then click
UPnP". Refer to the following picture. You can view the external IP address of the NVR. Input
the external IP address plus port in the IE address bar to access the NVR such as
http://183.17.254.19:81.
11.1.6

NAT Configuration

Click StartàSettingsàNetworkàNAT to go to the interface for NAT configuration. Check
"Enable" and then select the NAT server address (nat.autonat.com by default). Click "Apply"
to save the settings.
11.1.7

View Network Status

Click StartàSettingsàNetworkàNetwork Status to view the network status or click
the tool bar at the bottom of the live preview interface to view network status conveniently.

11.2 Basic Configuration

11.2.1

Common Configuration

Click StartàSettingsàSystemàBasicàGeneral Settings to go to the following interface. Set
the device name, device No., language, video format and resolution. Enable or disable wizard,
"Log In Automatically" and "Log Out Automatically" (if checked, you can set the wait time).
Click "Apply" to save the settings.
to modify the port until the UPnP status turns to "Valid
80
Transcendent NVR Series
on