Basic Operation Guide; Startup & Shutdown; Startup; Shutdown - Vitek TRANSCENDENT VT-TR5HA Series Manual

Basic Operation Guide

2.1 Startup & Shutdown
Please make sure all the connections are done properly before you power op the unit. Proper
startup and shutdown are crucial to extending the life of your device.
2.1.1

Startup

Connect a monitor to the VGA/HDMI interface of the DVR.
Connect the mouse and power. The device will boot and the power LED will turn blue.
A WIZARD window will pop up (you should select the display language the first time you
use the DVR). Refer to 3.1 Startup Wizard for details.
2.1.2

Shutdown

You can shutdown the device by using remote controller or mouse.
By remote controller:
Press Power button. This will take you to a shutdown window. The unit will power off
after a while by clicking "OK" button.
Disconnect the power.
By mouse:
Click StartàShutdown to pop up the Shutdown window. Select "Shutdown" in the
window. The unit will power off after a while by clicking "OK" button.
Disconnect the power.

2.2 Remote Controller

It uses two AAA size batteries.
Open the battery cover of the remote controller.
Place batteries. Please take sure of the polarity (+ and -).
Replace the battery cover.
Key points to check in case the remote doesn't work.
1. Check batteries polarity.
2. Check the remaining charge in the batteries.
3. Check IR controller sensor for any blockage.
If it still doesn't work, please try a new remote control or contact your dealers. You can just
point the IR sensor of the remote controller towards the IR receiver of the DVR to control it
when you are controlling multiple devices by remote controller.
There are two kinds of remote controller. The interface of remote controller is shown as below.
2 Basic Operation Guide
7
DVR User Manual