Hydraulic Fluid And Filter; Hydraulic Fluid And Filter Change Procedures - Terex R160T Service & Repair Manual

Compact Track Loader
13. Maintenance

Hydraulic Fluid and Filter

The hydraulic fluid should be changed every 500
service hours, and the hydraulic filter should be
changed every 250 hours. Hydrostatic components
require extremely clean oil for long service life.
Hydraulic Fluid and Filter Change
Procedures
Hot oil can cause personal injury. Make sure the
oil is cool before removing any components or lines.
Allow the machine to cool thoroughly and relax all
hydraulic circuits before performing this procedure.
NOTICE
Extreme care must be taken when changing the hydraulic
fluid. Before starting the procedure, make sure the ma-
chine is in a clean working environment. Precautions
should be taken to prevent any debris from entering the
hydrostatic system.
Collect and contain liquids in a suitable contain-
er. Dispose of all liquids according to local regula-
tions and mandates.
Hydraulic Fluid
Drain Plug
Figure 16-2
1. Locate and remove the hydraulic fluid drain plug
and drain the fluid into a suitable container.
Figure 16-3
2. Clean the area around the filter assembly, which
is located on the top of the hydraulic reservoir.
Filter
Element
Figure 16-4
3. Turn the hydraulic filter counter clockwise and
remove the filter
4. Change the filter element and replace the filter in
the tank.
5. Fill with manufacturer-approved hydraulic fluid.
13-2
Filter
Assembly