Table of Contents
Advertisement
Compact Track Loader
11. Undercarriage Disassembly and Assembly
Drive Sprocket Removal and
Installation
The tools required to remove and install the drive
sprocket assembly are listed in table 11-6. Use manu-
facturer recommended tools whenever possible.
Table 11-6
Required Tools
Combination/socket wrench
Snap ring pliers
Puller
Hammer/chisel
Removal
1. Perform the outboard bearing removal procedure
as described on page 11-5 of this chapter.
Figure 11-20
2. Remove the nuts securing the sprocket to the drive
motor, then carefully remove the drive sprocket.
Installation
1. To install the drive sprocket, reverse the removal
procedure.
Drive Motor Removal and
Installation
The tools required to remove and install the drive
motor are listed in table 11-7. Use manufacturer rec-
ommended tools whenever possible.
Table 11-7
Required Tools
Combination/socket wrench
Crow's foot
Removal
1. Perform the drive sprocket removal procedure as
described on page 11-6 of this chapter.
Figure 11-21
2. Remove the bolts securing the drive motor to the
drive table as shown.
Figure 11-22
3. Disconnect the various hoses from the drive motor
(noting their positions and orientations for
reassembly), then remove the drive motor from the
machine. (cap or plug all tubes/hoses/fittings)
Installation
1. To install the drive motor, reverse the removal pro-
cedure.
11-6
Advertisement
Table of Contents
