Table of Contents
Advertisement
Compact Track Loader
7. Radiator/Oil Cooler Disassembly and Assembly
Fan Guard Removal
Figure 7-1
1. Remove the bolts that secure the fan guard to
the fan shroud.
2. Remove the fan guard from the engine com-
partment.
Fan Guard Installation
1. Position the fan guard over the fan and against
the fan shroud.
2. Install the capscrews that secure the fan guard
to the fan guard mounts.
Radiator/Cooler Removal and
Installation
The tools required for radiator/cooler removal and
installations are listed in Table 7-2. Use manufactur-
er-recommended tools whenever possible.
Table 7-2
Required Tools
Combination Wrench
Socket Wrench
Screwdriver
Radiator/Cooler Removal
Hot oil can cause personal injury. Make sure the
oil is cool before removing any components or lines.
Remove the oil filler cap only when the engine is
stopped and has been allowed to cool thoroughly.
Personal injury can result from hot coolant,
steam and alkali.
At operating temperature, engine coolant is hot and
under pressure. The radiator and hoses contain hot
coolant and steam. Allow the machine to cool thor-
oughly prior to performing service or repair proce-
dures to avoid burns.
Remove the filler cap slowly to relieve pressure only
when the engine is stopped and the machine has been
allowed to cool thoroughly.
Cooling system conditioner contains alkali. Avoid
contact with skin and eyes.
Collect and contain liquids in a suitable contain-
er. Dispose of all liquids according to local regula-
tions and mandates.
1. Drain the hydraulic fluid. Refer to Chapter 13.
Hydraulic Fluid and Filter Change.
7-2
Advertisement
Table of Contents
