Table of Contents
Advertisement
Outboard Bearing Removal and
Installation
The tools required to remove and install the outboard
bearing assembly are listed in table 11-5. Use manu-
facturer recommended tools whenever possible.
Table 11-5
Required Tools
Combination/socket wrench
Snap ring pliers
Puller
Hammer/chisel
Removal
Figure 11-15
1. Remove the four bolts securing the bearing to the
mounting plate.
Figure 11-16
2. Remove the 3 bolts securing the mounting plate to
the drive table, then use a chisel to gently sepa-
rate the two components. Remove the mounting
plate from the machine.
11. Undercarriage Disassembly and Assembly
Figure 11-17
3. Use a hammer to drive a screwdriver in along the
edge of the rubber cap. the pry the cap out as
shown. (the cap must be replaced after service)
Figure 11-18
4. Use a snap ring pliers to remove the snap ring
retainer from the shaft as shown.
Figure 11-19
5. Use a puller to remove the bearing assembly from
the machine as shown.
Installation
1. To install the outboard bearing, reverse the
removal procedure.
11-5
Compact Track Loader
Advertisement
Table of Contents
