Hydraulic Filter Change; Accessory Belt - Terex R190T Operation And Maintenance Manual

7.8 Hydraulic Filter Change

The hydraulic filter should be changed every 250 hours. Hydrostatic components
require extremely clean oil in order to have a long service life. Use caution when
changing the hydraulic filter. Before beginning the procedure, make sure the
machine is in a clean working environment. Take any necessary measures to pre-
vent dirt or debris from entering the hydraulic system.
To change the hydraulic filter:
1. Shut the machine down according to the procedure in section 5.13.
2. Allow the machine to cool, then release any residual pressure in the
hydraulic system by following the procedure in section 4.7 of this manual.
3. Locate the hydraulic filter behind the operator enclosure, under the left
rubber plug (item 2, fig. 7.7-2).
4. Clean around the filter head, then remove the three bolts securing the cover
and remove it.
5. Remove the old filter from the housing and replace it with a new element.
Dispose of the used filter according to local mandates.
6. Reinstall the cover and rubber plug as found upon disassembly.
Note: Should a hydraulic hose or fitting need to be removed for maintenance or
service, always inspect for damage prior to re-installation. If none is found it may
be reused; if damaged, replace the part.

7.9 Accessory Belt

The engine uses a belt to drive accessories like the alternator, water pump, and
cooling fan. Belts typically stretch and wear during their service life. As a result,
the accessory belt on the R160T / R190T should be visually inspected daily for
tension, condition, and presence prior to operating your machine.
To check drive belt:
1. Shut the machine down according to the procedure in section 5.13, allow
the machine to cool thoroughly.
2. Raise the hood at the rear of the machine to access the belt.
3. Visually inspect the belt to make sure it is present, tight on the pulleys and
and in good condition.
69
7 MAINTENANCE
R160T / R190T US O&M
0404-490 2014-06