Hydraulic Oil Filter - Terex TL80 Operating Instructions Manual

7.9.11 Hydraulic oil filter

After major repairs the filter cartridge of
the hydraulic oil filter must also be
replaced after the test run.
Changing the filter insert
• Unscrew the oil dipstick (51/1).
• With the aid of a tool, remove the filter cover
(53/1).
• Remove the filter element (53/5) along with the
inlet connection (53/3) by pulling and turning at
the same time.
• Remove the filter element from the inlet
connection and
regulations.
• Ensure that the seal (53/2) in the cover and the
O-ring (53/4) on the inlet connection are in
faultless condition and replace any damaged
parts.
• Push a new filter element onto the inlet
connection and insert together in filter.
• Screw back on the filter cover (53/1) and tighten
using a torque of 20Nm.
• Screw back in the oil dipstick.
• Check the tightness of the filter by means of a
test run.
TL80
dispose of according
3
Fig. 51 Hydraulic oil tank
to
1
2
3
4
5
Fig. 53 Hydraulic oil filter
Maintenance and Care 7
1 2
4
L834-051-1
L834-053
89