Terex R160T Service & Repair Manual page 61

Hide thumbs Also See for R160T:

Table of Contents

Compact Track Loader

11. Undercarriage Disassembly and Assembly

11-27

5. Remove the bearing out of the front of the hub as

shown as well as the metal face seal half and rub-

ber ring from the rear of the hub. (fig. 11-27)

Part #: 0403-550

Part #: 0403-548

11-28

11-29

Bearing

6. Press the center seal, rear bearing/race, and seal

retainer out of the assembly from the front of the

hub using tools 0403-548 and 0403-550. (fig. 11-

28, 11-29)

Note: The center seal will be destroyed during removal

and must be replaced upon reassembly.

7. Press the front race out of the hub from the rear

Center seal

Note: Take care not to drop the metal face seal halves.

The sealing surfaces are surface ground and have an

Rear race

extremely fine finish. If scratched or disfigured, the

seal will not function as intended.

Seal retainer

Note: Now is a good time to inspect the components

for damage or wear. If the bearings do not roll smooth-

ly when rotated, replace them. If the seals appear worn

or damaged, replace them. If the wheels are worn or

damaged, replace them. If the components appear to

be in good working condition, you may reuse them.

11-8

Part #: 0403-550

Part #: 0403-546

11-30

11-31

using tools 0403-546 and 0403-550.

(fig. 11-30, 11-31)

Table of Contents