Table of Contents
Advertisement
Figure 5-18
3. Reconnect the gauge connector.
4. Install the light bar. Refer to Chapter 5. Light Bar
Installation procedure.
Lap Bar Gas Assist Spring
Removal and Installation
The tools required for gas assist spring removal and
installation are listed in Table 5-4. Use manufactur-
er-recommended tools whenever possible.
Table 5-4
Required Tools
Screwdriver
Lap Bar Gas Assist Spring Removal
Gas Assist
Spring
Raise Lap Bar
(Shown in Down
Position)
Figure 5-19
1. Put the lap bar in the UP position to relieve ten-
sion on the lap bar gas assist spring.
5. Operator Enclosure Disassembly and Assembly
Figure 5-20
2. Using a small screwdriver, remove the retaining
clip from each end of the gas assist spring.
Figure 5-21
3. Remove the gas assist spring by pulling both
ends out from the ball joints.
Lap Bar Gas Assist Spring Installation
Spring Location
Figure 5-22
1. Put the lap bar in the UP position to minimize
tension on the lap bar gas assist spring during
installation.
5-5
Compact Track Loader
Remove
Retaining Clip
Gas Assist
Raise Lap Bar
(Shown in Down
Position)
Advertisement
Table of Contents
