Table of Contents
Advertisement
Remove
Pin
Figure 12-6
8. Remove the forward pin assembly.
Figure 12-7
9. Remove the lift cylinder from the machine.
Lift Cylinder/Tilt Cylinder Installation
Note: Reverse the above steps to install the cylinder.
Note: Begin the lift cylinder installation with the loader
arms lowered and resting about 6 inches (15.24 cm) off
the ground on a mechanical support. This is the position
the loader arms were in following lift cylinder removal.
12. Loader Disassembly and Assembly
Quick-Coupler Block /
Pressure Release Valve
Removal and Installation
The tools required for low-flow relief valve removal
and installation are listed in Table 12-2. Use
manufacturer-recommended tools whenever
possible.
Table 12-2
Required Tools
Combination Wrench
Socket Wrench
Pressure Release Valve Removal
Hot oil can cause personal injury. Lower any
attachments and make sure the oil is cool before
removing any components or lines.
Remove the oil filler cap only when the engine is
stopped and the machine has been allowed to cool
thoroughly
Collect and contain liquids in a suitable
container. Dispose of all liquids according to local
regulations and mandates.
Note: During disassembly, cap all hoses and fittings to
prevent fluid loss and contamination of the system fluids.
1. Lower the lift arms to the ground.
2. Turn the ignition switch to the OFF position.
12-3
Compact Track Loader
Advertisement
Table of Contents
