Table of Contents
Advertisement
11-44
20. If necessary, use a needle dispenser to fill any
places in the bearing that are not full of grease to
ensure adequate lubrication. (fig. 11-44)
11-45
21. Remove the allen plug in the center portion of the
hub. (fig. 11-45)
11-46
22. Add 1 oz. of Terex 10W-30 Heavy Duty Engine Oil
to the hub as shown, then reinstall the plug and
tighten. (fig. 11-46)
23. The hub assembly is now ready to be reinstalled.
To install it onto the machine, reverse steps 1-3 on
page 11-7 of this procedure. Make sure to read the
note below step 3 prior to reinstalling.
24. Repeat this procedure throughout the undercar-
riage as necessary to repair worn or damaged
components and restore proper function.
11. Undercarriage Disassembly and Assembly
11-11
Compact Track Loader
Advertisement
Table of Contents
