Table of Contents
Advertisement
WAFER-CV-D25501/N26001 3.5" SBC
Step 3:
Connect the audio devices. Connect one speaker to the line-in audio jack, one
speaker to the line-out audio jack and a microphone to the mic-in audio jack.
4.6.2 LVDS LCD Installation
The WAFER-CV-D25501/N26001 can be connected to a TFT LCD screen through the
LVDS
crimp
connectors
WAFER-CV-D25501/N26001, please follow the steps below.
Step 1:
Locate the connector. The locations of the LVDS connectors are shown in
Chapter 3.
Step 2:
Insert the cable connector. Insert the connector from the LVDS PCB driving
board to the LVDS connector as shown in Figure 4-10. When connecting the
connectors, make sure the pins are properly aligned.
WARNING:
The diagram below is merely for illustration. The configuration and
connection of the cables from the TFT LCD screen being installed may
be different. Please refer to the installation manual that came with the
TFT LCD screen.
on
the
board.
To
connect
a
TFT
LCD
to
the
Page 51
Advertisement
Table of Contents
