WAFER-CV-D25501/N26001 3.5" SBC
Step 1:
Locate the connector. The location of the keyboard/mouse Y-cable connector
is shown in Chapter 3.
Step 2:
Align the connectors. Correctly align pin 1 on the cable connector with pin 1 on
the WAFER-CV-D25501/N26001 keyboard/mouse connector. See Figure 4-20.
Step 3:
Insert the cable
the keyboard/mouse connector on the WAFER-CV-D25501/N26001, connect
the cable connector to the on-board connector. See Figure 4-20.
Figure 4-20: Keyboard/mouse Y-cable Connection
Step 4:
Attach PS/2 connectors to the chassis. The keyboard/mouse Y-cable
connector is connected to two PS/2 connectors. To secure the PS/2 connectors
to the chassis please refer to the installation instructions that came with the
chassis.
Step 5:
Connect the keyboard and mouse. Once the PS/2 connectors are connected
to the chassis, a keyboard and mouse can each be connected to one of the
PS/2 connectors. The keyboard PS/2 connector and mouse PS/2 connector are
connectors.
Once the cable connector is properly aligned with
Page 59