Figure 4-7: Heat Sink Retention Screws - IEI Technology WAFER-CV-D25501 Series User Manual

WARNING:
When running the WAFER-CV-D25501/N26001, do not put the
WAFER-CV-D25501/N26001 directly on a surface that can not
dissipate system heat, especially the wooden or plastic desk. It is
highly recommended to run the WAFER-CV-D25501/N26001
on a heat dissipation surface or
using copper pillars to hold the board up from the desk below
When the WAFER-CV-D25501/N26001 is shipped it is secured to a heat sink with five
retention screws. If the WAFER-CV-D25501/N26001 must be removed from the heat sink,
the five retention screws must be removed.

Figure 4-7: Heat Sink Retention Screws

Page 48
WAFER-CV-D25501/N26001 3.5" SBC