Auger Vertical Adjustment - A30-D - MacDon A30-S Operator's Manual

6.17.4.4 Auger Vertical Adjustment – A30-D
a. Open LH end shield.
b. Loosen auger drive chain (A) as follows:
B
1. Loosen nut (B) on idler sprocket support.
2. Turn adjuster bolt (C) to loosen chain (A).
C
c. Loosen four nuts (C).
d. Loosen jam-nut on adjuster bolt (D) and turn
adjuster bolt (D) to adjust auger vertical position.
e. Tighten jam-nut and four nuts (C).
f. Tighten auger drive chain (A) as follows:
1. Turn adjuster bolt (C) to achieve (5 mm)
slack at mid-span of chain (A).
2. Tighten nut (B) on idler sprocket support.
3. Rotate auger and check chain for slack at
tightest point.
sprocket to achieve required slack.
g. Close LH end shield.
Form # 169000
A
C
D
Re-adjust position of idler
OPERATION
h. Open RH end shield.
i. Loosen reel drive belts (E) as follows:
1. Loosen nuts (F).
2. Loosen jam-nut on adjuster bolt (G).
3. Turn adjuster bolt (G) to loosen reel drive
belts.
j. Loosen nuts (H).
k. Loosen jam-nuts on adjuster bolts (J).
l. Turn adjuster bolts (J) to adjust auger vertical
position.
m. Tighten nuts (H) and jam-nuts.
60
G
F
E
E
H
J
(continued next page)
Model Year - 2009