Pull-Type - Flatbed; Loading - Pull-Type - MacDon A30-S Operator's Manual

6.8.3

Pull-Type - Flatbed

To transport the windrower on a flatbed trailer,
proceed as follows:
CAUTION
Use the following
transporting the windrower on a flatbed
trailer.
6.8.3.1 Loading – Pull-Type
a. Lower the windrower to the ground and move
the cylinder lock-out valve handle to the
horizontal position at both lift cylinders.
b. Retract header angle control link to minimum.
c. Unhook windrower from tractor.
Section 6.5, Windrower/Tractor Unhook.
d. Tie hoses to APT.
e. Remove tall crop dividers, if equipped.
f. Remove complete forming shield group as
follows:
B
1. Remove pins (B).
2. Disassemble adjuster bars (C) from side
deflectors (D). Note orientation of hardware.
Form # 169000
OPERATION
procedure when
Refer to
D
C
42
F
3. Remove nuts (E) and drop side deflectors
from frame (F).
4. Remove eight bolts (G) attaching forming
shield cover to frame.
H
5. Remove two bolts (H) and lower rear of
forming shield to ground.
6. Remove two bolts (J) and detach forming
shield from frame.
g. Remove pin at rod end of APT steering cylinder
and move cylinder away from frame. Re-insert
pin in clevis.
E
G
G
G
J
(continued next page)
Model Year - 2009