Header Detachment - Self-Propelled; A30-S And A30-D Detachment - MacDon A30-S Operator's Manual

6.7 HEADER DETACHMENT – SELF-
PROPELLED
CAUTION
To prevent accidental movement of tractor,
shut off engine, engage parking brake, and
remove key.
6.7.1

A30-S and A30-D Detachment

B
a. Disengage rubber latch (A) and lift driveline
shield (B) to open position.
ELECTRICAL
RETURN
CASE DRAIN
HEADER DRIVE
b. Disconnect electrical connector by turning collar
counterclockwise and
disengage.
Form # 169000
A
pulling connector
OPERATION
c. Disconnect hoses from hydraulic motor as
follows:
1. Line up slot (C) in collar with pin (D) on
connector.
2. Push collar toward pin and pull connector to
disengage.
3. Install caps on connectors and hose ends (if
equipped).
E
d. Move hose bundle (E) from header and locate
on tractor LH side with hose ends in support (F)
and under lever (G).
e. Rotate lever (G) clockwise and push to engage
bracket.
f. Locate electrical harness through support (F)
and attach cap to electrical connector.
g. Close header driveline shield and move tractor
platform back to closed position.
h. Detach header from tractor. Refer to the M100,
to
or M150 & M200 Self-Propelled Windrower
Operator's
mechanically detaching the header from the self-
propelled windrower.
36
D
C
C
G
Manuals for procedures
Model Year - 2009
F
for