Changing Gearbox Oil - MacDon A30-S Operator's Manual

l. Adjust roll timing. Refer to Section 6.17.11.2,
Roll Timing and Alignment.
m. Clean off excess sealant from motor flange and
gearbox face.
n. Apply light coat of silicone to motor flange and
position motor on gearbox as shown until
mounting holes are aligned and pinion engages
gear in gearbox.
U
o. Install bolts (U) and washers and torque to 75
ft∙lbf (102 N∙m).
p. Reconnect hoses to motor.
q. Close all shields before operating machine.
Form # 169000
MAINTENANCE/SERVICE
7.13.9
a. Lower header to ground.
b. Open driveline shield.
c. Place a suitable container under gearbox drain
d. Remove breather (A), check plug (B) and drain
e. Allow oil to drain.
f.
g. Oil is at required level when it runs out of check
156

Changing Gearbox Oil

NOTE
Change conditioner
lubricant after the first 50 hours operation
and every 1000 hours (or 3 years)
thereafter.
to collect oil.
B
plug (C).
Replace drain plug (C) and add oil at (A) to
required level. Use Gear Lubricant, SAE 85W-
140, API Service Class GL-5, 1.5 qts (1.4 liters).
plug (B).
drive gearbox
A
C
Model Year - 2009