Tire Inflation; Skid Shoe Wear Plate Replacement; Electrical - MacDon A30-S Operator's Manual

7.14.4

Tire Inflation

Check tire pressure daily.
(207 kPa).
WARNING
Service tires safely.
•
A tire can explode during inflation and
•
cause serious injury or death.
Do not stand over tire. Use a clip-on
•
chuck and extension hose.
Never increase air pressure beyond 35
•
psi (241 kPa) to seat the bead on the rim.
• Replace the tire if it has a defect.
Replace a wheel rim, which has cracks,
•
wear or severe rust.
• Never weld a wheel rim.
Never use force on an inflated or partially
•
inflated tire.
Make sure the tire is correctly seated
•
before inflating to operating pressure.
If the tire is not in correct position on the
•
rim, or is too full of air, the tire bead can
loosen on one side, causing air to leak at
high speed and with great force. An air
leak of this nature can thrust the tire in
any direction, endangering anyone in the
area.
Make sure all the air is removed from a
•
tire before removing the tire from a rim.
Do not remove, install or make repairs to
•
a tire on a rim unless you have the
proper equipment and experience to
perform the job.
Take the tire and rim to a qualified tire
•
repair shop.
Form # 169000
MAINTENANCE/SERVICE
Maintain 30 psi
158
7.15 SKID SHOE WEAR PLATE
REPLACEMENT
The skid shoes are equipped with replaceable
wear plates that can be reversed for increase
service life. It is recommended that the wear
plates be replaced when the skid shoe weldment
becomes exposed.
follows:
a. Raise header and engage lift cylinder stops.
b. Remove bolts (A) and remove wear plates (B).
c. Position replacement wear plate (B) as shown.
(The same wear plate can be reinstalled but in
the reverse position).
d. Secure wear plate with bolts and nuts (A).
e. Disengage lift cylinder stops.

7.16 ELECTRICAL

a. Use electrical tape and wire clips as required to
prevent wires from dragging or rubbing.
b. Keep lights clean and replace burnt bulbs.
c. To replace light bulbs:
1. Using a phillips screwdriver, remove screws
from fixture and remove plastic lens.
Bulb Part No. - Trade #1156
2. Replace bulb and reinstall plastic lens and
screws.
Replace wear plates as
A
B
Model Year - 2009