Header Attachment - Self-Propelled; A30-S And A30-D Attachment - MacDon A30-S Operator's Manual

6.6 HEADER ATTACHMENT – SELF-
PROPELLED
Refer to the M100, or M150 & M200 Self-
Propelled Windrower Operator's Manuals for
procedures for mechanically attaching the auger
header to the self-propelled windrower. Refer to
the following procedures for electrical and
hydraulic connections.
hydraulic hoses and electrical harness are
located on the LH cab-forward side of the
tractor.
CAUTION
To prevent accidental movement of tractor,
shut off engine, engage parking brake, and
remove key.
B
a. Disengage rubber latch (A) and open driveline
shield (B).
D
The header drive hydraulics and electrical
harness are located on the LH cab-
forward side of the tractor.
b. Remove the cap (C) from electrical connector,
and remove connector from support bracket (D).
Form # 169000
The header
A
C
NOTE
OPERATION
F
drive
c. Push lever (E) inboard to disengage bracket and
rotate counterclockwise to release the hose
bundle (F).
d. Move hose bundle (F) to header.
e. Rotate lever (E) clockwise and engage bracket
to store.
f. Refer to following sections for your specific
header model for hose attachment details.
6.6.1

A30-S and A30-D Attachment

a. Pass hoses (F) from tractor through support (H)
and access hole (J) in header frame.
b. Remove cover on header electrical receptacle
(K).
c. Push connector onto receptacle and turn collar
on connector to lock it in place.
d. Attach cover to mating cover on tractor wiring
harness.
e. Remove caps from hydraulic couplers and clean
if necessary.
33
E
F
H
K
J
(continued next page)
G
C
Model Year - 2009