Drive Shields; Lift Cylinder Lock-Outs; Self-Propelled; Pull-Type - MacDon A30-S Operator's Manual

7.4 DRIVE SHIELDS

B
a. To open the LH and right drive shields on the
header, press a screwdriver against latch in
opening at (A).
CAUTION
Ensure shield lock engages in the open
position as shown at (B) before letting go of
shield.
b. To close, push shield slightly farther open and
move lock (B) out of engagement slot. Lower
shield by hand and release about 12" from fully
closed position. Shield will self-latch.
D
c. To open the driveline shield, disengage rubber
latch (C) and open shield (D).
d. To close, lower shield and engage rubber latch.
Form # 169000
MAINTENANCE/SERVICE
A
C

7.5 LIFT CYLINDER LOCK-OUTS

7.5.1

Self-Propelled

Refer to M100, or M150 & M200 Self-Propelled
Windrower Operator's Manuals.
7.5.2

Pull-Type

DANGER
To avoid bodily injury or death from
unexpected
machine; stop engine, remove key and
engage lift cylinder lock-out valves before
going under machine for any reason.
a. Raise the header fully, shut off engine and
remove key.
b. Move handle to horizontal position on both
header lift cylinder lock-out valves.
88
start-up or fall of
Model Year - 2009
raised