Lubrication; Greasing Procedure; Lubrication Points - MacDon A30-S Operator's Manual

7.6 LUBRICATION

CAUTION
To avoid personal injury, before servicing
windrower or opening drive covers, follow
procedures in Section 6.1, Preparation for
Servicing.
Refer to Section 6.4, Recommended Lubricants
for recommended greases.
SAMPLE GREASE DECAL
The greasing points are marked on the machine
by decals showing a grease gun (A), and grease
interval (B) in hours of operation. Log hours of
operation and use the "Maintenance Checklist"
provided to keep a record of scheduled
maintenance.
Maintenance Schedule.
7.6.1

Greasing Procedure

a. Wipe grease fitting with a clean cloth before
greasing, to avoid injecting dirt and grit.
b. Inject grease through fitting with grease gun until
grease overflows fitting, except where noted.
c. Leave excess grease on fitting to keep out dirt.
d. Replace any loose
immediately.
e. If fitting will not take grease, remove and clean
thoroughly. Also clean lubricant passageway.
Replace fitting if necessary.
Form # 169000
MAINTENANCE/SERVICE
Refer to Section
or broken fittings
7.6.2
The lubrication requirements depend on the
model of windrower that is being serviced.
Refer to the specified pages for identifying
lubrication points for your specific model.
A30-S HEADER
A30-D HEADER
A40-D HEADER
HAY CONDITIONER
PULL-TYPE CARRIER
DRIVELINES
7.17,
89

Lubrication Points

Pages 90-91
Pages 92-93
Pages 94-95
Page 96
Page 97
Page 98
Model Year - 2009