Tine And Bearing Replacement, Opposite Cam - Section Y - MacDon A30-S Operator's Manual

7.10.2.3 Tine and Bearing Replacement,
Opposite Cam – Section Y
DISC #3
Y
A
Y
DISC #4
a. Remove shoulder bolts (A) and keeper (B)
connecting tine bar extension "Z" to section "Y"
at reel disc #4.
b. Remove flangette mounting bolts (C) at reel disc
#4.
c. Lift tine bar away from reel arm and remove tine
bar extension "Z"
assembly.
d. To replace tine bar bearing, refer to Section
7.6.3, Sealed Bearing Replacement.
e. Replace tine as follows:
Y
1. Remove bolt (D) and keeper (E) on tine to
be replaced.
2. Remove bolts and keepers on tines as
required to
damaged or worn tine.
3. Slide tines off tine bar.
Form # 169000
MAINTENANCE/SERVICE
DISC #4
Z
C
Z
B
complete with bearing
D
E
DISC #4
facilitate replacement
Y
4. Install tines on tine bar and secure with bolts
(D and keepers (E). Install nut with tapered
side against tine bar. Do not install bolts in
end tine at this time.
f. Install tine bar extension "Z" including bearing to
section "Y" at reel disc #4.
g. Install shoulder bolts (A) and keeper (B) with tine
to connect tine bar extension.
h. Install flangette mounting bolts (C) at reel disc
#4. Tighten to 16-20 ft∙lbf (21-27 N∙m).
of
136
C
A
B
DISC #4
Model Year - 2009
Z