Reel Fore-Aft Position A40-D; Reel Vertical Position A40-D - MacDon A30-S Operator's Manual

6.17.5.3 Reel Fore-Aft Position A40-D

The reel must be adjusted equally on both
sides.
a. Open LH end shield.
A
B
b. Loosen the four nuts (A).
c. Loosen jam-nut on adjuster bolt (B) and turn bolt
(B) to adjust reel fore-aft position.
d. Tighten jam-nut.
e. Tighten nuts (A).
f. Open RH end shield.
C
g. Loosen the four nuts (C).
h. Loosen jam-nut on adjuster bolt (D) and turn bolt
(D) to adjust reel fore-aft position.
i. Tighten jam-nut.
j. Tighten nuts (C).
k. Close drive shields before engaging header.
Form # 169000
NOTE
A
C
D
OPERATION

6.17.5.4 Reel Vertical Position A40-D

Adjustment at forward adjuster bolt should
be 0.47 inches (12 mm) lower than at rear
adjuster bolt.
a. Open LH end shield.
D
b. Loosen the four nuts (D).
c. Loosen jam-nuts on adjuster bolts (E) turn bolts
(E) to raise or lower reel.
d. Tighten jam-nuts.
e. Tighten nuts (D).
66
NOTE
D
E
(continued next page)
Model Year - 2009