Cutting Height Adjustment - MacDon A30-S Operator's Manual

6.17.7.1 Cutting Height Adjustment:

a. Raise header and engage lift cylinder lockouts.
A
b. Remove pins (A) at each skid shoe or gauge
roller.
c. Raise or lower skid shoe or gauge roller to
desired position.
d. Replace pins (A).
e. Check that skid shoes or gauge rollers are
adjusted to the same position.
f. Check header float and adjust if required. Refer
to Section 6.17.9, Header Flotation.
LH and RH skid shoes are standard
equipment, and two more inner skid shoes
may be added if required. A set of two
gauge rollers may be installed in place of
the outer skid shoes.
Form # 169000
A
NOTE
OPERATION
69
Model Year - 2009