Kerberos Commands - Lantronix SLB088411-01 User Manual

5. Click the Apply button.
Note: You must reboot the unit before your changes will take effect.

Kerberos Commands

These commands for the command line interface correspond to the web page entries
described above.
To configure the SLB branch office manager to use Kerberos to authenticate users
who log in via the Web, SSH, Telnet, or the console port:
set kerberos <one or more parameters>
Parameters:
To set user group and permissions for Kerberos users:
set kerberos group <default|power|admin>
To set permissions for Kerberos users not already defined by the user rights
group:
set kerberos permissions <Permission List>
where
<Permission List> is one or more of nt, sv, dt, lu, ra, sk, um, dp,
pc, rs, rc, dr, wb, sn, ad
To remove a permission, type a minus sign before the two-letter abbreviation for a user
right.
To set a default custom menu for Kerberos users:
set kerberos custommenu <Menu Name>
SLB™ Branch Office Manager User Guide
PC Card
Right to enter modem settings for PC cards.
Power Outlets Right to configure power outlets.
accessoutlets <Outlet List>
breakseq <1-10 Chars>
clearports <Port List>
dataports <Port List>
escapeseq <1-10 Chars>
ipaddr <Key Distribution Center IP Address>
kdc <Key Distribution Center>
listenports <Port List>
port <Key Distribution Center TCP Port>
realm <Kerberos Realm>
state <enable|disable>
useldapforlookup <enable|disable>
11: User Authentication
162